Krone Comprima F 155 XC - 13.15 Drawbar; 13.15.1 Hitches on the Drawbar

Maintenance
232
Pos: 52.76 /Übersc hriften/Überschrif ten 2/A-E/D /Deichsel @ 2 36\mod_1394 526379904_78. docx @ 187 3562 @ 2 @ 1
13.15 Drawbar
Pos: 52.77 /BA/ Wartung/Rundballe npresse/Deic hsel CF/CV @ 245\mod_13 95843200211 _78.docx @ 19 12690 @ @ 1
RPN00049
Fig.
198
• Tighten screws after 10 operating hours
• Check screws every 50 operating hours
Pos: 52.78 /Übersc hriften/Überschrif ten 3/U-Z/Z ugösen an der D eichsel @ 236\mod_139 4528187810_78.d ocx @ 1873 833 @ 3 @ 1
13.15.1 Hitches on the Drawbar
Pos: 52.79 /BA/ Wartung/Zugös en/Zugösen a=43 an der Deichs el @ 236\ mod_1394528163 742_78.doc x @ 1873804 @ @ 1
KDW02330
a
Fig.
199
Caution!
If the wear limit of the socket in the towing ring has been reached, it must be replaced. Work on
the drawbar must only be performed by trained professionals.
The wear limit of the socket in the towing ring (1) is a = 43 mm. If this value is exceeded, the
socket must be replaced. To minimise wear, clean the socket and towing ring daily and lubricate
them with grease.
Note
The towing ring should be coupled always horizontally in the towing hitch. Observe the correct
combination of towing ring and towing hitch (observe the specifications on the type plate!)
Pos: 52.80 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1