Operation
132
Pos: 48.55 /Übersc hriften/Überschrif ten 2/U-Z/ VVor dem Pr essen @ 59\m od_12973498 86078_78.doc x @ 556726 @ 2 @ 1
11.6 Before Baling
Pos: 48.56 /Übersc hriften/Überschrif ten 3/P-T/RR ollboden s pannen @ 192\ mod_13820851 34347_78.doc x @ 1637727 @ 3 @ 1
11.6.1 Tensioning the floor conveyor
Pos: 48.57 /Ab kürzungen /Abkürz ungen sprac hneutral/Rundb allenpressen/Co mprima V @ 256\mod_139 7714229979_ 0.docx @ 196267 0 @ @ 1
Comprima V
Pos: 48.58 /BA/Be dienung /Ru ndballenpresse/R ollbodenHin weise Rollboden sp annen @ 59\ mod_12973 50006477_78.d ocx @ 556749 @ @ 1
Note
Clamp the floor conveyor of the bale chamber before the P.T.O. shaft is turned on.
Pos: 48.59 /BA/Be dienung /Ru ndballenpresse/Bil d Handrad @ 105\mod_1 333020713111_ 78.docx @ 950 800 @ @ 1
Fig.
Pos: 48.60 /BA/Be dienung /Ru ndballenpresse/H andrad eindreh en @ 59\ mod_1297350412 235_78.doc x @ 556776 @ @ 1
To do this:
• Screw in the handwheel (2) completely (working position)
Pos: 48.61 /BA/Be dienung /Ru ndballenpresse/Pr essdruck einstellenPressdru ck einstellen @ 59\mod_12 97351058932_7 8.docx @ 556 940 @ @ 1
After an extended standstill time of the machine and before it is started up for the first time:
• Open the tailgate and close it again once (see menu “Manual Operation Baler”, open/close
bale chamber)
• Turn on the PTO shaft
This will build up the baling pressure to the factory setting or the last pressure set.
The baling pressure can be changed with the turn dial (3) (see Chapter entitled “Baling pressure
setting”
Due to the hydraulically design of the accumulator connection block it can occur that the baling
pressure drops throughout a certain period of time. In order to reach the set baling pressure
again, open the tailgate once again and close it.
Pos: 48.62 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1
To Next Page
Loading...
