Krone Comprima F 155 XC - 11.9 Pick-up; 11.9.1 Adjusting the working height

Operation
134
Pos: 48.70.1 /Üb erschriften/Üb erschriften 2/P- T/P/Pick up @ 1\mod_120 1791975201_0.doc x @ 54586 @ 2 @ 1
11.9 Pick-up
Pos: 48.70.2 /Üb erschriften/Üb erschriften 3/A- E/A/Arbeitshöh e einstellen @ 27\mod_1246 341892615_78. docx @ 26681 7 @ 3 @ 1
11.9.1 Adjusting the working height
Pos: 48.70.3 /B A/Einstellungen/ Pick-up / R ollenniederhalter/Hin weis Fahren i m Vorgewende @ 20\mod _123857849021 3_78.docx @ 22 1874 @ @ 1
Note
Lift the Pick-up for driving in the headland or when driving backward!
Pos: 48.70.4 /B A/Sicherheit/8. V oraussetzung en/Handlungsan weisung für all e Maschinen/Han dlungsanweisu ng: Maschine stills etzen und sic hern @ 274\mod_14043 65253849_78.d ocx @ 206515 1 @ @ 1
• Shut down and safeguard the machine, see chapter Safety -> Safety routines, "Shutting
down and safeguarding the machine".
Pos: 48.70.5 /B A/Einstellungen/ Pick-up / R ollenniederhalter/Pic k-up Grund einstellung_Bil d_Comprima CF C V RP025 @ 49 5\mod_14894 16822554_78. docx @ 34023 77 @ @ 1
COM00527
1
3
2
Fig.
105
Pos: 48.70.6 /B A/Einstellungen/ Pick-up / R ollenniederhalter/Pic k-up Grund einstellung_Text-H inweis_Co mprima @ 495\ mod_14894173 97677_78.doc x @ 3402660 @ @ 1
Note
When adjusting the pick-up, the drawbar height of the machine must be adjusted to the tractor
(see chapter "Initial start-up").
Pos: 48.70.7 /B A/Einstellungen/ Pick-up / R ollenniederhalter/Pic k-up Grund einstellung_Text _Comprima CF CV RP025 @ 495\mod_148 9417247973_ 78.docx @ 3402 506 @ @ 1
Adjust the pick-up (3) working height, ensuring the distance from the tines to the ground is
approx. 20–30 mm. Additionally adjust the pick-up (3) working height according to the prevailing
ground conditions.
• Raise the pick-up (3) using the tractor hydraulics.
Carry out the following settings on both sides of the pick-up:
• Remove the linch pin (2).
• Push the perforated bar (1) to the required position and secure it using the linch pin (2).
• Hydraulically lower the pick-up (3).
• Check whether the distance from the tines to the ground is approx. 20-30 mm.
• Reset the perforated bar (1) as needed.
Pos: 48.70.8 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.d ocx @ 4165 @ @ 1