Krone Comprima F 155 XC - 13.9 Setting the sensors; 13.10 Checking and setting the axial play of the brake disc at the wrapping material brake

Maintenance
221
Pos: 52.46 /Übersc hriften/Überschrif ten 2/P-T/S /Sensoren ei nstellen @ 282\ mod_140628 0895701_78.doc x @ 2171125 @ 2 @ 1
13.9 Setting the sensors
Pos: 52.47 /BA/ Wartung/Rundballe npresse/Sens oren/Zur Eins tellung besti mmter Sensoren sie he Kapitel @ 4 97\mod_1 490338392174_7 8.docx @ 34 13586 @ @ 1
For setting certain sensors, see chapter Terminal – Menus, "Menu 15-2 'Sensor test'".
Pos: 52.48 /Übersc hriften/Überschrif ten 2/A-E/ A/Axiales Spiel der Bremssc heibe an der Bi ndematerialbre mse prüfen und einstellen @ 5 13\mod_150358 5957205_78.d ocx @ 353251 3 @ 2 @ 1
13.10 Checking and setting the axial play of the brake disc at the wrapping material brake
Pos: 52.49 /BA/ Wartung/Rundballe npresse/Bind ematerialbrems e Wartung/ Axiales Spiel der Bremsschei be an der Binde materialbremse pr üfen und einst ellen_Bild @ 5 14\mod_15 03659059592_78. docx @ 35329 48 @ @ 1
COM00493
4 52 31 3
6
X
4
Fig.
189
Pos: 52.50 /BA/ Wartung/Rundballe npresse/Bind ematerialbrems e Wartung/A xiales Spiel der Bre msscheibe an der Bindemateri albremse einstellen_ei nleitung @ 514\m od_150365914 8842_78.docx @ 3533019 @ @ 1
Among other settings, the axial play of the brake disc (4) at the wrapping material brake must
be adjusted before setting the sensor B02 "Tying cycle active".
The axial play must be X=0.5–1.5 mm.
Pos: 52.51 /BA/ Wartung/Rundballe npresse/Bind ematerialbrems e Wartung/A xiales Spiel der Bre msscheibe an der Binde materialbremse einstellen_text @ 514\mod_ 1503659291794 _78.docx @ 353 3050 @ @ 1
• To release the wrapping material brake, press the lever (5) down.
• Measure the axial play X of the brake disc (4) to the adjusting collar (1).
If the axial play is not X=0.5–1.5 mm:
• Raise the lever (6).
• Swivel the brake disc (4) with the roll holder (3) forward and pull off the brake disc (4).
• Remove the threaded pin (2) from the adjusting collar (1).
• By means of shim rings, adjust the desired axial play X.
• Mount the threaded pin (2) in the adjusting collar (1).
• Push the brake disc (4) on the roll holder (3) and swivel it back into the machine.
Pos: 52.52 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1