Krone Comprima F 155 XC - 13.20.3 Conveyor Auger Drive; 13.20.4 Roller drive

Maintenance
243
Pos: 52.130 /Übers chriften/Übersc hriften 3/F-J/F /Fördersch neckenantrieb_ Antriebskettensp annung @ 468\ mod_146969 0626230_78.doc x @ 3159312 @ 3 @ 1
13.20.3 Conveyor Auger Drive
Pos: 52.131 /BA /Wartung/Rundb allenpresse/Ket ten spannenSpa nnen Ketten F örderschnecke C F/CV @ 75\ mod_13094 42690939_78.d ocx @ 663624 @ @ 1
1
RPN00057_1
2
a
3
Fig.
209
The auger conveyor drive (1) is located on the pick-up on the left-hand side of the machine.
The drive chain is tensioned by the clamping element (2).
Check the Chain Tension:
The length of the spring when tightened must be a = 30 mm.
Correct the Chain Tension:
• Turn the nut (3) to increase or reduce the spring tension of the compression spring (2) until
distance a= approx. 30 mm is set
Pos: 52.132 /Übers chriften/Übersc hriften 3/U-Z/ Walzenantri eb_Antriebskett enspannung @ 488\mod_148 2228107655_78. docx @ 328 2527 @ 3 @ 1
13.20.4 Roller drive
Pos: 52.133 /BA /Wartung/Rundb allenpresse/Ket ten spannen/S pannen Ketten Walzenantrieb _Comprima @ 336\mod_143 0198526772_ 78.docx @ 255 9101 @ @ 1
1
RPN00055
2
a
2
3
Fig.
210
The roller drive (1) is located on the right side of the machine.
Check the Chain Tension:
The length of the spring when tightened must be a=220 mm.
Correct the Chain Tension:
• Turn the nut (3) to increase or reduce the spring tension of the compression spring (2) until
distance a=220 mm is set.
Pos: 52.134 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1