Krone Comprima F 155 XC - 13.19.1 Adjusting the deflection roller

Maintenance
237
Pos: 52.104.7 /Ü berschriften/Ü berschriften 3/U- Z/Umlenkrolle versetzen @ 218\mod_1390 928585702_7 8.docx @ 17694 95 @ 3 @ 1
13.19.1 Adjusting the deflection roller
Pos: 52.104.8 / BA/Wartung/Ru ndballenpresse/U mlenkrolle verse tzen/Umlen krolle versetzen _Voraussetzung en @ 215\ mod_139081115 8175_78.doc x @ 1760609 @ @ 1
Prerequisites
– The left side protector is raised.
– The left plastic protector is detached.
Pos: 52.104.9 / BA/Wartung/Ru ndballenpresse/U mlenkrolle verse tzen/Umlen krolle versetzen _Bild @ 215\ mod_1390813 804816_78.doc x @ 1761351 @ @ 1
VPN00616
1
2
3
a
b
Fig.
203
Pos: 52.104.10 /B A/Wartung/R undballenpresse/U mlenkrolle versetzen/Umlenkr olle versetze n_Text @ 237 \mod_1394637 069965_78.doc x @ 1879416 @ @ 1
• Dismount scraper (1).
• Remove the threaded pin from the adjusting ring on the deflection pulley (2) and remove the
adjusting ring.
• Dismount deflection shaft (2) and mount with deflection shaft (3) in position (a).
• Push the adjusting ring onto the deflection shaft (2) and secure with threaded pin.
• Mount scraper (1) at a higher position.
• Check whether the tensioning rocker still touches the belt (brush marks). Move scraper and
deflection pulley up into hole (b), if necessary.
Pos: 52.104.11 /B A/Wartung/R undballenpresse/U mlenkrolle versetzen/Hin weis: Umlenkroll e nur 1 Loch höher montiere n @ 215\mod_ 1390814073967 _78.docx @ 176 1437 @ @ 1
Note
Only mount the deflection roller (3) 1 hole higher as otherwise the belt is unnecessary loaded.
Pos: 52.105 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311226_0. docx @ 4165 @ @ 1