Krone Comprima F 155 XC - 16.3 Malfunctions During Twine Tying

Malfunctions - Causes and Remedies
275
Pos: 58.12 /Übersc hriften/Überschrif ten 2/P-T/S /Störungen b ei der Garnbin dung @ 374\ mod_1442492794 011_78.doc x @ 2721558 @ 2 @ 1
16.3 Malfunctions During Twine Tying
Pos: 58.13 /BA/Stör ungen - Ursa chen und Be hebung/Rundball enpressen/Ta bellarische A uflistung Garnbin dung @ 436\ mod_1456480 642883_78.docx @ 2993757 @ @ 1
Malfunction
Possible cause
Remedy
The round bale is only tied
on one side.
Magnetic coupling is set
incorrectly.
• Set magnetic coupling.
“Twine stop” sensor set
incorrectly.
• Set the “Twine stop”
sensor
Caution! This sensor has
two flags. Two positions of
twine guide slide are
evaluated.
Fault in the twine run.
• Check twine run.
Twine guide slide does not
move.
• Clean twine guide slide.
There are no 4 twines
available on the round bale.
Fault in the twine run.
• Check twine run.
Twine roll(s) empty.
• Fill the twine reserves.
The twine ends are knotted
incorrectly.
• Knot twine ends properly.
Twine slips from the round
bale at the bale corners.
The lateral boundary is set
incorrectly.
• Set the lateral boundary.
Twine is too far away from
the bale edge.
The lateral boundary is set
incorrectly.
• Set the lateral boundary.
The bale edges are not
wrapped sufficiently.
The number of start wraps
and end wraps is too low.
• Increase number of start
wraps and end wraps.
The twine consumption per
bale is too high or too low.
The number of start wraps
and end wraps is too low or
too high.
• Increase or reduce the
number of start wraps
and end wraps.
Wrong selection of stepped
pulley on the twine bar.
• Adapt the selection of the
stepped pulley.
The twine motion indicator
does not work.
The twine brake is too
powerful when feeding.
• Set twine brake.
The twine brake is not
powerful enough when tying.
• Set twine brake.
Crop deposits below the
twine motion indicator.
• Clean twine motion
indicator.
The twine brake is not
powerful enough.
• Replace brake plates on
the twine brake.
The brake plates on the
twine brake are worn.
Twine gets between the net
rollers.
The front net roller is too far
away from the spiral roller.
• Set the distance of the
net roller.
Twine gets into the rotor.
The front net roller is too far
away from the spiral roller.
• Set the distance of the
net roller.
The distance between lower
twine chute and front net
roller is too great.
• Set the distance of the
lower twine chute.
Pos: 58.14 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_1196175311 226_0.docx @ 4165 @ @ 1