Krone Comprima F 155 XC - 6.7 Adjusting the baling pressure

6 Terminal machine functions
6.7 Adjusting the baling pressure
32
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en
6.7 Adjusting the baling pressure
Comprima F
50
%
1
100
75
50
25
0
125cm
5
∑
1
55 %
100
75
50
25
0
50
%
55 %
1
2
EQG003-038
1 Adjusted target baling pressure in % 2 Actual baling pressure in %
Adjusting the baling pressure via the scroll wheel
 Select the blue value to be changed using the scroll wheel.
ð The icon is shown in reverse colours.
 Press the scroll wheel.
ð An input field opens.
 To increase or reduce the value, turn the scroll wheel.
 To save the value, press the scroll wheel.
ð The setting is accepted, the input field closes.
Adjusting the baling pressure via the touch-capable display
 Tap the blue value to be changed.
ð An input field opens.
 Enter the desired value and press
.
ð The value is saved and the input field exited.
6.8 Operating the hydraulic blade group control system
The blades can be switched centrally in two groups A and B without installing and removing
them by means of the hydraulic blade group control system. The half set of blades (blade group
A or B) or the complete set of blades (blade groups A and B) can be swivelled in and out from
the tractor seat.
The following functions of the blade group control system can be selected. The set function
appears on the status line of the display. The key or the grey surface on the key shows the
icons in this sequence every time the key is pressed.