Krone Comprima F 155 XC - KRONE Operation Unit Alpha; 8.1 Overview; 8.1.1 General Description

KRONE Operation Unit Alpha
89
Pos: 42.1 /Übersc hriften/Übersc hriften 1/K-O/KR ONE Bedie neinheit Alpha @ 362\mod_ 1439554740443_7 8.docx @ 267 0150 @ 1 @ 1
8 KRONE Operation Unit Alpha
Pos: 42.2 /Übersc hriften/Übersc hriften 2/U-Z/U/Ü bersicht @ 5 3\mod_12899 00374656_78.d ocx @ 506510 @ 2 @ 1
8.1 Overview
Pos: 42.3 /BA/Sich erheit/7. Gefa hrenhinweise alt /Achtung - Bedieneinheit sch ützen @ 0\ mod_120030824 7867_78.docx @ 39598 @ @ 1
Caution! - Protect Control Unit.
Effect: Damage to the control unit
• The control unit must be protected against water.
• If the machine is not used for an extended period of time (for example during the winter),
the control unit must be stored in a dry place.
• For mounting and repair jobs, especially for welding jobs on the machine, disconnect the
power supply to the control unit. Overvoltage can damage the control unit.
Pos: 42.4 /Übersc hriften/Übersc hriften 3/A-E/A /Allgemeine Be schreibung @ 55\mod_12 94737886734_78. docx @ 53176 8 @ 3 @ 1
8.1.1 General Description
Pos: 42.5 /WHB/El ektrik/Rundball enpresse/Alph a (Medium)/Allge meine Besc hreibung - Al pha @ 78\mod _1312872706 661_78.docx @ 67 1380 @ @ 1
RPM00013
AB CD EF GH
2
3
6
7
8
10
RPM00011_1
Fig.
61
The electronic equipment of the machine consists essentially of the job computer, the control
unit and the control and function elements.
The job computer (1) is located front right on the machine under the side hood.
Its functions are:
• Control of the actuators installed on the machine
• Sensors/actuators diagnostics
The control unit (2) communicates information to the driver and performs settings for the
operation of the machine. This information is received and further processed by the job
computer.
Pos: 42.6 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_119617 5311226_0.docx @ 4165 @ @ 1