Krone Comprima F 155 XC - ISOBUS Shortcut Button Not Available; KRONE BETA II Terminal

KRONE BETA II terminal 2
ISOBUS Shortcut Button not available 2.1
RP701-10 , RP701-11 , RP701-20 , RP701-21 , RP701-30 , RP701-31 , RP701-40 , RP701-41 , RP701-51
Comfort 1.0_en 11
2 KRONE BETA II terminal
NOTICE
Penetration of water in the terminal could lead to malfunction. As a result, the machine
can no longer be operated safely.
 Protect the terminal from water.
 If the machine is not used for an extended period of time (for example in winter), the
terminal must be stored in a dry place.
 For mounting and repair jobs, especially for welding jobs on the machine, disconnect the
power supply to the terminal.
2
EQG001-002
The electronic equipment of the machine consists essentially of the job computer (1), the
terminal (2) and the control and function elements.
The job computer (1) is located on the right side of the machine under the side hood.
Functions of the job computer (1):
• Control of actuator system installed on the machine.
• Transmission of error messages.
• Evaluation of sensor system.
• Diagnostics of sensor system and actuator system.
The driver gets information by means of the terminal (2) and settings for the operation of the
machine are performed which are gathered by the job computer and further processed.
2.1 ISOBUS Shortcut Button not available
ISBISB
1
EQG000-022
The KRONE BETA II terminal is not equipped with ISOBUS Shortcut Button. The icon (1) is
shown in the display. It is not possible to switch off machine functions via ISOBUS Shortcut
Button.