Krone Comprima F 155 XC - 11.2 Travelling speed

Operation
124
Pos: 48.8 /BA/Bedi enung /Run dballenpresse/ hohe Ballendic hte @ 35\mod_ 12561252272 22_78.docx @ 32 6331 @ @ 1
If the cutting system is switched on during baling, the bale density will increase
substantially, which makes it necessary to reduce the baling pressure.
Pos: 48.9 /BA/Bedi enung /Run dballenpresse/ Kurzes Stroh @ 66\mod_13025 08002442_78. docx @ 61645 5 @ @ 1
To do this:
Short, crumbly straw:
• Reduce the number of cutting blades or turn off the cutting system or remove the cutters.
The blades can be stored on the left-hand side of the machine
• Switch off P.T.O. shaft in headland position
Small, flat swaths:
• Reduce PTO speed
or
• Increase travelling speed
Straw varies greatly in structure. Even if no cutting system is used, it is not always possible to
work with the highest possible pressure.
Pos: 48.10 /BA/Be dienung /Ru ndballenpresse/Hin weis Weic hkern einstellen @ 80\mod_13 15899545989 _78.docx @ 708 199 @ @ 1
Note
The inner bale core must only be set to soft with Comprima V150/180(XC) (see section
"Adjusting the Soft Core Setting").
Pos: 48.11 /BA/Be dienung /Ru ndballenpresse/F ahrenFahrgesc hwindigkeit @ 3 5\mod_12 56125846472_7 8.docx @ 326 411 @ 2 @ 1
11.2 Travelling speed
The forward speed during use depends on the following factors:
• type of crops
• moisture content of the crops
• height of swaths
• ground conditions
Note
The recommended travelling speed is 5 - 12 km/h and must be adapted to local conditions in
actual practice.
• Do not overload the round baler.
• When baling a round bale, reduce speed at the start and end of the baling process.
Pos: 48.12 /BA/Be dienung /Ru ndballenpresse/R ollbodenEinst ellung bei Schlup f des Rollbod ens @ 59\m od_12973483033 56_78.docx @ 556695 @ @ 1
Setting in case of slip of the floor conveyor if the grass is very wet and only with little
structure
• Drive with less blades or turn off the blades or remove them and reduce the baling pressure
• Adjust inner bale core to soft (see Chapter entitled “Adapt Soft Core”)
Pos: 48.13 /BA/Be dienung /Ru ndballenpresse/F ahrenohne M esser fahren @ 56\mod_12949 02558671_78. docx @ 537 071 @ @ 1
• Driving without cutters
CAUTION!
Damage to the machine
• There must be no driving with cutters and switched off cutter base, since the cutters then
have no guidance to the cutting system and the tine can be incised by the cutter.
Pos: 48.14 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1