Krone Comprima F 155 XC - 11.13.2 Setting of Bale Diameter Display (Comprima V 150 (XC); V 180 (XC); V 210 XC) (Medium Electronics)

Operation
145
Pos: 48.84 /Übersc hriften/Überschrif ten 3/A-E/ E/Einstellung d er Ballendurc hmesseranzeige (Comprima V 150 (XC) / V 180 ( XC) / V 210 XC) (M edium) @ 364\mod _1440426892310_ 78.docx @ 26 77766 @ 3 @ 1
11.13.2 Setting of Bale Diameter Display (Comprima V 150 (XC) / V 180 (XC) / V 210 XC) (Medium
Electronics)
Pos: 48.85 /WHB/ Grundeinstellu ngen/Rundballe npresse/Einstell ung der Ballen durchmesseran zeige (COMPRIM A V150 / V1 80) (Medium) @ 346\mod _1435065971680 _78.docx @ 2611656 @ @ 1
WHBCP075
Fig.
116
The cable (1) on right-hand and left-hand machine side is used to set both diameter displays on
the right-hand machine side.
Note
Dimension “Y" must be the same on both sides.
• If the bale chamber is empty and the tailgate is closed and locked, the indicators should be
lifted somewhat away from the stop (2) (cable is under tension).
• The cable length can be adjusted on the threaded piece (3).
• Make certain the rocker arm (4) rests on the stop (5) (relieve the bale formation conveyor, if
necessary).
• The bale chamber must be closed and empty.
Basic setting:
X= 30 mm
Pos: 48.86 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1