Krone Comprima F 155 XC - 11.13.1 Preselecting Bale Diameter (Comprima V 150 (XC); V 180 (XC); V 210 XC) (Medium Electronics)

Operation
144
Pos: 48.81 /Übersc hriften/Überschrif ten 3/A-E/ B/Ballendurch messer vor wählen (Comprima V 150 (XC) / V 1 80 (XC) / V 21 0 XC) (Medium) @ 364\mo d_14404263131 63_78.docx @ 2677735 @ 3 @ 1
11.13.1 Preselecting Bale Diameter (Comprima V 150 (XC) / V 180 (XC) / V 210 XC) (Medium
Electronics)
Pos: 48.82 /BA/Be dienung /Ru ndballenpresse/Balle ndurchmesser /Bild und T ext Ballendurc hmesser vorwähl en @ 81\ mod_1315914552 339_78.doc x @ 709482 @ @ 1
The setting of the bale diameter is preselected by using an adjusting segment located behind
the front right guard and is set from inside the twine box (right machine side) via the wing nut
(2).
1
2
RP000036
Fig.
115
Note
Never perform the preselection of the bale diameter with the system in automatic mode.
1. Switch on the operation.
2. Manually raise the baling pressure indicators (1) to the desired position (bale diameter) (e.g.
10=1.0 m, 12=1.2 m).
3. Loosen the wing nut (2) in the twine box and move the screw with wing nut in the oblong
hole until the pilot lamps on the KRONE operation terminal Alpha light up and the horn
sounds.
4. Tighten the fly nut inside the twine box again
Pos: 48.83 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1