Krone Comprima F 155 XC - 11.14 Setting Baling Pressure

Operation
146
Pos: 48.87.1 /Üb erschriften/Üb erschriften 2/P- T/PPressdruc k einstellen @ 59\ mod_129766 6400713_78.d ocx @ 558581 @ 2 @ 1
11.14 Setting Baling Pressure
Pos: 48.87.2 /A bkürzungen /Abkürz ungen sprac hneutral/Rundb allenpressen/Co mprima V @ 256\mod_ 1397714229979_ 0.docx @ 1962 670 @ @ 1
Comprima V
Pos: 48.87.3 /B A/Bedienung /Ru ndballenpress e/Pressdruck einst ellenHin weis Druckbereich_C omprima @ 59\ mod_129 7669041046_78.d ocx @ 5587 93 @ @ 1
Note
A pressure range of 50-180 bar is preset for the baling pressure setting.
Pos: 48.87.4 /B A/Bedienung /Ru ndballenpress e/Pressdruck einst ellenTabelle Dr uckbereich @ 59\mod_1 29766913446 7_78.docx @ 558 820 @ @ 1
Crop
Pressure range (bar)
Hay
low
Straw
medium/high
Silage
high
Pos: 48.87.5 /B A/Bedienung /Ru ndballenpress e/Pressdruck einst ellenBild Pres sdruck Handr ad @ 59\mod _1297666635 329_78.doc x @ 558608 @ @ 1
VPN00001_2
1
2
3
Fig.
117
Pos: 48.87.6 /B A/Bedienung /Ru ndballenpress e/Pressdruck einst ellenPressdru ck einstellen - Handräder h ereindrehen @ 321\mod_14 24759429768 _78.docx @ 24776 81 @ @ 1
The baling pressure is set on the machine.
• Completely screw in hand wheels (2) and (3).
• Pick up crops with the machine until a baling pressure builds up which is approx. 10 bar
above the desired baling pressure.
• Set the desired pressure by using the handwheel (3).
Right-hand turn = increase the pressure
Left-hand turn = decrease the pressure
Pos: 48.87.7 /B A/Bedienung /Ru ndballenpress e/Pressdruck einst ellenHin weis Pressdruck 180_C omprima C_F @ 321\ mod_1424764533 579_78.doc x @ 2478814 @ @ 1
Note
The baling pressure will only adjust itself when the chamber is supplied with crops.
The maximum pressure must not exceed 180 bar. When opening the tailgate, the maximum
pressure must not exceed 210 bar.
The minimum pressure must not fall below 50 bar. Do not use the machine to perform work at a
baling pressure of less than 50 bar. After an extended downtime before start-up of the machine,
open tailgate once and close it. As a result, minimum pressure is built up. Then set the desired
baling pressure as described above.
Pos: 48.87.8 /B A/Bedienung /Ru ndballenpress e/Hinweis Eingriff e am Druc kregler @ 81\ mod_1315908706 413_78.doc x @ 709234 @ @ 1
Note
Manipulations on the pressure controller will cause the guarantee to become void.
Pos: 48.87.9 /L ayout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.d ocx @ 4165 @ @ 1