Krone Comprima F 155 XC - 13.17 Novo Grip belt on the floor conveyor; 13.18 Checking the Safety Rollers of Single Blade Locking Device

Maintenance
235
Pos: 52.100 /BA /Wartung/Rundb allenpresse/R ollbodenNovo Gr ip @ 216\m od_1390828279 663_78.doc x @ 1762682 @ 2 @ 1
13.17 Novo Grip belt on the floor conveyor
The Novo Grip belts consist of a composite material (rubber and tissue). Under load, franges
come into being on the cutting edges. They must be removed regularly.
• Check the Novo Grip belts at least once a week on the formation of fringes and cut off the
fringes, if necessary.
Pos: 52.101 /BA /Wartung/Rundb allenpresse/Ko ntrolle der Sic herungsrollen der Einzelmessersic herung CF/C V @ 75\mo d_130943318 3952_78.docx @ 663320 @ 2 @ 1
13.18 Checking the Safety Rollers of Single Blade Locking Device
A
B
RPN00079
1
Fig.
201
The safety rollers (1) on the levers of the single blade locking device must turn slightly when
they are turned on (tension of safety springs with multipurpose key after blades are installed). If
they do not, the result will be an increased amount of force when switching. The individual knife
retention will not work properly (increased blade breakage). To prevent this, lubricate the safety
rollers (1) if they no longer turn easily. However, at least once a year.
Pos: 52.102 /BA /Wartung/Lade wagen/Hinweis EP Langzeitfett N LGI2 verwend en @ 13\ mod_12252871 58244_78.doc x @ 154964 @ @ 1
Note
To lubricate the safety rollers, use an EP long-term grease NLGI 2 order No. 926 045 0
(400 grams).
Pos: 52.103 /Layo ut Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0.d ocx @ 4165 @ @ 1