Krone Comprima F 155 XC - 13.19 Checks and maintenance on rear floor conveyor

Maintenance
236
Pos: 52.104.1 /Ü berschriften/Ü berschriften 2/P-T /PPrüfung u nd Wartung am hi nteren Rollb oden @ 215\ mod_139081188 3572_78.doc x @ 1761006 @ 2 @ 1
13.19 Checks and maintenance on rear floor conveyor
Pos: 52.104.2 / Abkürzungen /Ab kürzungen spra chneutral/Rund ballenpressen/C omprima V @ 256\mod_1 397714229979 _0.docx @ 196 2670 @ @ 1
Comprima V
Pos: 52.104.3 / BA/Wartung/Ru ndballenpresse/U mlenkrolle verse tzen/Hinweis: Prüfung nach ca. 1000 produzi erten Ballen durc hführen @ 215\mod_139081 6403004_78.d ocx @ 1761 845 @ @ 1
Note
Perform the following check after producing around 1000 bales to prevent damage or tearing
of the rear floor conveyor.
Pos: 52.104.4 / BA/Wartung/Ru ndballenpresse/U mlenkrolle verse tzen/Absta nd zwischen den Spannschwi ngen prüfen_Bild @ 215\mod_ 139081370341 1_78.docx @ 1 761322 @ @ 1
a
3
COM00348
1 2
b
Fig.
202
Pos: 52.104.5 / BA/Wartung/Ru ndballenpresse /Umlenkrolle versetzen/Absta nd zwischen den Spannschwing en prüfen_Te xt @ 215\mod _1390812253 560_78.docx @ 1761294 @ @ 1
At a bale diameter (a) between 800 and 1000 mm, check whether the distance (b) between the
front tensioning rocker (1) and the rear tensioning rocker (2) is at least 20 mm.
If the distance is at least 20 mm, everything is OK.
If the distance is less than 20 mm, the deflection roller (3) must be adjusted, see "Adjusting the
deflection roller" maintenance chapter.
Pos: 52.104.6 / Layout Module /---------------Seitenumbruch---------------- @ 0\mod_1196 175311226_0. docx @ 4165 @ @ 1