Krone Comprima F 155 XC - 11.9.3 Adjusting the bearing pressure relief for the pick-up

Operation
136
Pos: 48.70.14 /Ü berschriften/Ü berschriften 3/A- E/A/Auflage druckentlastung der Pick-up ei nstellen @ 345\ mod_143437 2832641_78.doc x @ 2607260 @ 3 @ 1
11.9.3 Adjusting the bearing pressure relief for the pick-up
Pos: 48.70.15 / BA/Einstellunge n/Pick-up / Roll enniederhalter /Auflagedrucken tlastung der Pic k-up einstelle n_Bild1_Com prima CF CV RP 025 @ 495\m od_148942009 2034_78.docx @ 3402928 @ @ 1
COM00528
X
1
2
3
Fig.
107
Pos: 48.70.16 / BA/Einstellunge n/Pick-up / Roll enniederhalter /Auflagedrucken tlastung der Pic k-up einstelle n_Text1_Compri ma CF CV RP 025 @ 495\ mod_1489420 266972_78.docx @ 3402987 @ @ 1
In order to be able to pass over unevenness better, the pick-up is relieved on both machine
sides by means of the spring (3). The spring (3) can be set on the ring screw (2).
KRONE recommends the following setting:
– Dimension X (left machine side): 150 mm
– Dimension X (right machine side): 42 mm
Prerequisite
– Load on the guide wheels is sufficiently relieved.
• On the left and right machine side, check whether the dimensions stated above match.
• Screw in or unscrew the nut (1) as much as needed until the dimension X stated above has
been set.
Pos: 48.71 /La yout Module /---------------Seitenumbruch---------------- @ 0\mod_11961 75311226_0.doc x @ 4165 @ @ 1