4
Operation
Operation
2
e3871457
13
Electrical reverse current braking
Slowly or quickly releasing the accelerator
pedals to the neutral position allows the
braking effect to be sensitively controlled,
from gentle to hard braking.
Allow the accelerator pedals
(1) or (3) to
move to the neutral positio
n.
The LBC electronics brake the truck.
Actuate the accelerator pedal for the
opposite drive direction.
This will increase the reve
rse current braking.
NOTE
If required, this function can be adjusted using
the diagnostic program so that the effect
is greater or smaller. Contact your service
partner.
WARNING
Risk of accident
Depending on the charging state of the battery,
electrical reverse current braking may be insuffici-
ent, meaning that the maximum permissible speed
of the truck is exceeded. For this reason, the driving
speed must be adapted to the respective environ-
mental conditions.
Display_e0053b
10:30
03.03.2015
4
20
h
min
EFF
Automatic brake
If the truck is braked to a standstill, the auto-
matic brake is activated.
The"Parkingbr
ake activated" symbol (see
arrow) flashes i
n the display unit.
When stopping on gradients, the truck is held
electrically until the automatic brake becomes
active.
Actuate the accelerator pedal again.
The brake is automatica
lly released.
126 Operating Instructions – 3888011701 EN – 12/2017
To Next Page
Loading...
