Service work
5
Service plan
Regular service, at least every 12 months
Clean the integrated charger and check that the integrated charger is working correctly (the charg-
ing process starts).
Check the filter for the electrolyte circulation pump for the integrated charger and replace the filter
as required.
Hydraulics
Check the oil level in th
e hydraulic system
Check the hydraulic sy
stem for leak tightness.
Clean the radiator.
Check the bleeder val
ve on the hydraulic tank for correct operation.
Check the pre-load of the hose lines.
Load lift system
Check the condition of the lift mast.
Clean and adjust
the lift mast chain and apply chain spray.
Check and lubricate the sideshift.
Check and lubri
cate the fork prong positioner.
Servicing work every 1000 hours, but as a minimum every 3 years
(exceptions in brackets)
Gearbox
Check the mounting of the drive axle (visual inspection).
Check the oil level in the planetary transmission and check for leak tightness.
Change the gearbox oil in the planetary transmission
(once after 1000 hours, again at 3000 hours and then every 3000 hours).
Chassis, bodywork and fittings
Check and lubricate the bearing points and joints.
Lubricate the bolts, hinges and interlocks on the battery door and the battery hood.
Check the battery side stop in the battery compartment.
Check the condition of the seat belt and check for correct operation.
Check the mountings of the chassis/counterweight/ballast weight (visual inspection).
Check the mounting of the tilt-cylinder supports (visual inspection).
Service the heating system.
Ch
assis frame
Check the wheels for damage, foreign objects and wear.
C
heck the condition of the antistatic belt.
Operating Instructions – 3888011701 EN – 12/2017 213
To Next Page
Loading...
