MacDon A40D - Maintenance Schedule;Record

262334 132 Revision A
4.5.1 Maintenance Schedule/Record
Auger Header
Maintenance
Record
Action:
üü - Check
SS - Lubricate
pp - Change
Hour meter reading
Date
Serviced by
Break-in
Refer to 4.5.2 Break-in Inspection, page 133.
100 Hours or Annually
ü
Conditioner drive gearbox
lubricant level
ü
Knife drive box bolt torque
ü
Knife drive box
Lubricant level
End of Season
Refer to 4.5.4 Storage, page 133.
10 Hours or Daily
ü
Hydraulic Hoses and Lines
2
S
Sections, guards,
And hold-downs
2
ü
Knife hold-downs
2
ü
Knife assembly
2
ü
Knife drive box bolt torque -
First 10 hours only
25 Hours
S
Knifehead
50 Hours
S
Auger shaft bearings
S
Gauge roller bearings
S
Main driveshaft bearings
S
Tine bar bearings
S
Reel shaft bearings
p
Conditioner gearbox oil -
First 50 hours only
S
Conditioner universal shafts
S
Roll pivots
S
Conditioner shaft bearings
S
Knife drive cross-shaft
p
Knife drive box oil -
First 50 hours only
MAINTENANCE AND SERVICING
2. A record of daily maintenance is not normally required, but is at the owner/operator’s discretion.