262334 190 Revision A
4.11 Straightening Auger Pans
The high density polyethylene auger pans are repairable and replaceable. Refer to your Dealer for details on replacing
the pans.
IMPORTANT:
To prolong the life of the auger pan, be sure to check that the reel tines do NOT contact the pans when adjusting the reel
position or the tine pitch.
Stones and other debris can deform the polyethylene pans. If this occurs, the pans can be straightened.
CAUTION
To avoid personal injury, before servicing header or opening drive covers, follow procedures in 4.1 Preparing for
Servicing, page 125, and 1 Safety, page 1.
1. Heat the deformed area with a heat gun until the polyethylene is almost sticky.
2. Push out the dent, and then apply a cold wet rag. Keep wetting the rag in cold water, and applying it on the area until
cool. This ensures the polyethylene retains its shape.
NOTE:
If the dent is too severe, and has stretched the polyethylene, it may be necessary to locally remove the polyethylene. Use a
plastic welder to rejoin the material. Replacement pans are also available from your Dealer.
MAINTENANCE AND SERVICING
To Next Page
Loading...
