MacDon A40D - Index

Index
A
A40D
auger drive ...................................................... 175
A40DX
auger drive ...................................................... 175
A40DX Auger Headers
float options with fixed deck ................................. 98
attaching/detaching
A40D auger header
attaching to M205 ........................................... 59
attaching to windrower
hydraulic hose routing – M100, M105, M205
only.......................................................... 65
modifications needed to attach header................ 41
A40D SP windrower header
attaching to windrower
M100 or M105............................................. 41
M150, M155, or M155E4 ............................... 47
M200 ......................................................... 53
A40D windrower header
detaching A40D from windrower ........................ 72
A40DX auger header
attaching to M1 Series windrower ...................... 36
detaching from M1 Series windrower .................. 39
detaching from M2 Series windrower .................. 33
A40DX Auger Headers
attaching to M2 Series windrower ...................... 29
auger and auger drives
auger pan
auger pan extensions for grass seed special........ 115
adjusting extensions ................................... 115
straightening auger pan .................................. 190
grass seed special auger design ........................... 114
replacing rubber fingers ..................................... 191
stripper bar ...................................................... 192
installing front stripper bar extensions............... 193
removing stripper bar ..................................... 192
replacing stripper bar ..................................... 193
auger positions ...................................................... 79
adjusting
auger fore-aft position...................................... 80
auger vertical position ...................................... 81
auger speeds
adjusting ........................................................... 79
B
bearings.............................................................. 141
belts, See knife drive belts
knife drive belt ................................................. 167
removing left side .......................................... 169
break-in inspections.............................................. 133
C
clearances
auger to stripper bar clearance....................... 79, 192
hold-down to knife section – DK .......................... 158
reel tine to header pan clearance........................... 86
conditioners ........................................................ 195
conditioning
conditioner rolls
adjusting conditioner roll gap........................... 101
adjusting conditioner roll tension ..................... 102
roll alignment
checking/adjusting...................................... 213
roll timing
checking/adjusting...................................... 216
forming shield, See forming shields
hydraulic motor, See hydraulic motors
conversion chart .................................................. 243
cutting heights
setting............................................................... 89
D
declaration of conformity ...........................................i
definitions............................................................. 23
deflectors
forming shield
assembling ................................................... 200
disassembling................................................ 199
installing ...................................................... 202
SP windrower headers
removing shield ......................................... 197
rear deflector (fluffer shield)
positioning rear deflector ................................ 104
side deflectors
positioning side deflectors............................... 104
dividers, See tall crop dividers
drive systems
A40D .............................................................. 167
A40DX............................................................. 167
drives
knife drive, See knife drives
driveshields
opening and closing........................................... 126
drying agents ....................................................... 123
E
electrical