MacDon A40D - Detaching A40 D Auger Header from M Series Self-Propelled Windrower

262334 72 Revision A
3.6 Detaching A40D Auger Header from M Series Self-Propelled
Windrower
Folow this procedure to detach an A40D Auger Header from an M Series Self-Propelled Windrower.
DANGER
To prevent injury or death from the unexpected start-up of the machine, always stop the engine and remove the key
from the ignition before leaving the operator’s seat for any reason.
1005656
A
B
Figure 3.97: M100 and M105
1. Move the left cab-forward platform to the rear of the
windrower.
2. Refer to the illustration relevant to your equipment, and
disconnect hydraulic hoses (A) and (B) from the windrower
valve(s).
1005275
A
B
Figure 3.98: M150 with Reverser Valve
– M155 and M155E4 Similar
OPERATION