Micromeritics ASAP 2460 - Unit Configuration

ASAP 2460 Operator’s Manual Unit Configuration
246-42800-01 - Aug 2013 4-29
Unit Configuration
Unit [n] > Unit Configuration
Use to display hardware/software configurations, calibrations, and gas selections of the connected
analyzer.
Field or Button Description
Configuration

group box
Displays the IP address used by the analysis program and the serial number
of the selected analyzer.
• Change IP - click to display the Unit IP Setup window. The IP address
and Subnet mask assigned during installation display. Do not edit these
fields unless instructed by a Micromeritics service representative.
• Board ID - click to read the board ID. The parameters on this window
cannot be edited.
Software Versions
group box
Displays the software versions of the MIC BIOS, controller, and analysis
program.
Gas Selections

group box
Select the analysis gases attached to inlet valves.
Options Displays options installed on the instrument.