2 ABOUT THE SOFTWARE
If a software update is required for the analyzer to support the Smart VacPrep, the software can be
downloaded from the internet at this location:
www.micromeritics.com/Smart-VacPrep-Software.aspx
The degasser software is installed as a part of the analyzer installation. During installation, an
IPaddress will be assigned to the unit allowing the unit to connect automatically during startup. Up to
three additional degasser units can be installed.
Menu options for the Smart VacPrep are provided on the SmartVacPrep menu.
Related Topics
See "Add or Remove a Smart VacPrep" below
ADD OR REMOVE A SMART VACPREP
A Smart VacPrep unit must be removed from one application before it can be added to another
application if they are running on the same subnet.
2 About the Software
Smart VacPrep Operator Manual 2 - 1
To Next Page
Loading...
Need help?
General
