1. Go to Smart VacPrep >Unit [n] >QuickStart Degas Conditions.
2. The six ports are represented by row numbers. Ports that are busy are grayed out and disabled.
Click Edit for the port to be configured.
3. Enter degas conditions using one of the following methods:
l To select degas conditions from a Degas Conditions file, click the dropdown arrow to the right
of the Degas Conditions field. If the file is not shown, select Browse , locate the file, then
click Load.
l To copy QuickStart Degas Conditions from another Smart VacPrep unit, select the unit and
port number to the right of the Copy QuickStart Degas Conditions from Smart VacPrep Unit
field..
l To enter degas conditions manually, complete the fields on the window. Reference the Degas
Conditions section of the Operator Manual
4.
Click Save. Repeat these steps for each port to be configured. If multiple ports will have the
same degas conditions parameters, click Edit on the port and use the Copy QuickStart Degas
Conditions from Smart VacPrep Unit [n] Port [n field to load the settings from the first port.
5. Repeat these steps for each applicable unit and port.
6. If using a Check Seal, verify that the Check Seal opener is installed in the Smart VacPrep port.
Follow the instructions included with the Check Seal for instructions on inserting the opener.
7. Load the sample into the sample tube. If using a Check Seal or TranSeal, insert it into the sample
tube.
8. Load the sample on the Smart VacPrep sample port.
9. Attach the heating mantle using the metal clip. If a straight wall tube is used, heating mantles with
elastic cords are available. Reference the Parts and Accessories section of the analyzer Operator
Manual.
QuickStart Degas Conditions
Smart VacPrep Operator Manual 3 - 3
To Next Page
Loading...
Need help?
General
