Mitutoyo HR-530 Series - PART C: Rockwell Hardness Test, Plastic Hardness Test (ISO2039-2); Test Flow

xvi
No. 99MBG518A
6 Installing or Removing the Bellows …………………………………………………B-15
6.1 Removing the Bellows ……………………………………………………………B-15
6.2 Installing the Bellows …………………………………………………………… B-19
7 Installing the Display Unit ………………………………………………………… B-23
PART C Rockwell Hardness Test, Plastic Hardness Test (ISO2039-2)
1 Test Flow ………………………………………………………………………………… C-1
1.1 Method to Test One Point ……………………………………………………… C-1
1.2 Method to Set a Group and Test Multiple Points ……………………………… C-2
1.3 Method to Fix the Test Position and Test ……………………………………… C-3
2 Method to Test One Point …………………………………………………………… C-5
2.1 Test Method Settings …………………………………………………………… C-6
2.2 Display Conditions Settings …………………………………………………… C-7
2.3 Scale Settings …………………………………………………………………… C-8
2.4 Mounting the Indenter …………………………………………………………… C-9
2.5 Test Time Settings ……………………………………………………………… C-9
2.6 Correction Value Settings ……………………………………………………… C-9
2.7 GO/NG Judgment Settings ………………………………………………………C-10
2.8 Setting the Specimen ……………………………………………………………C-10
2.9 Executing the Test ………………………………………………………………C-12
2.10 ConrmingtheTestResults ……………………………………………………C-14
2.10.1 ConrmingontheScreen ………………………………………………………………C-14
2.10.2 ConrmingwithExternalOutput ………………………………………………………C-14
2.10.3 Retesting ……………………………………………………………………………………C-14
3 Method to Set a Group and Test Multiple Points …………………………………C-15
3.1 Test Method Settings ……………………………………………………………C-15
3.2 Display Conditions Settings ……………………………………………………C-16
3.3 Scale Settings ……………………………………………………………………C-17
3.4 Mounting the Indenter ……………………………………………………………C-17
3.5 Test Time Settings ………………………………………………………………C-17
3.6 Correction Value Settings ………………………………………………………C-17
3.7 GO/NG Judgment Settings ………………………………………………………C-17
3.8 Group Settings ……………………………………………………………………C-18