Mitutoyo HR-530 Series - Method to Test One Point

xvii
No. 99MBG518A
3.9 Setting the Specimen ………………………………………………………… C-20
3.10 Executing the Test ………………………………………………………………C-21
3.10.1 Executing the Test (First Point) …………………………………………………………C-21
3.10.2 ConrmingtheTestResults(FirstPoint) …………………………………………… C-22
3.10.3 Executing the Test (Second Point) ………………………………………………………C-23
3.10.4 ConrmingtheTestResults(SecondPoint) ……………………………………………C-25
3.10.5 Testing from the Third Point Onwards …………………………………………………C-25
3.11 Retesting ……………………………………………………………………… C-26
4 Method to Fix the Test Position and Test …………………………………………C-27
4.1 Test Method Settings ……………………………………………………………C-27
4.2 Display Conditions Settings ……………………………………………………C-28
4.3 Scale Settings ………………………………………………………………… C-29
4.4 Mounting the Indenter ………………………………………………………… C-29
4.5 Test Time Settings …………………………………………………………… C-29
4.6 Correction Value Settings …………………………………………………… C-29
4.7 GO/NG Judgment Settings …………………………………………………… C-29
4.8 Test Position Registration …………………………………………………… C-30
4.9 Setting the Specimen ………………………………………………………… C-32
4.10 Executing the Test …………………………………………………………… C-34
4.11 ConrmingtheTestResults ………………………………………………… C-35
4.11.1 ConrmingontheScreen …………………………………………………………… C-35
4.11.2 ConrmingwithExternalOutput …………………………………………………… C-35
4.11.3 Retesting ………………………………………………………………………………… C-35
5 Executing Continuous Tests ……………………………………………………… C-37
PART D Plastic Hardness Test (ASTM D785-B)
1 Test Flow ………………………………………………………………………………… D-1
1.1 Method to Test One Point ……………………………………………………… D-1
1.2 Method to Set a Group and Test Multiple Points ……………………………… D-3
2 Method to Test One Point …………………………………………………………… D-5
2.1 Test Method Settings …………………………………………………………… D-6
2.2 Display Conditions Settings …………………………………………………… D-7
2.3 Mounting the Indenter …………………………………………………………… D-8
2.4 Test Time Settings ……………………………………………………………… D-8