Mitutoyo HR-530 Series - Method to Test One Point

xx
No. 99MBG518A
3.8 Testing the Test Block ……………………………………………………………E-28
3.8.1 Setting the Test Block ……………………………………………………………………E-28
3.8.2 Executing the Test ………………………………………………………………………E-28
3.8.3 ConrmingtheTestResults ……………………………………………………………E-29
3.8.4 Testing from the Second Point Onwards ………………………………………………E-30
3.8.5 TestingwithTestBlocksofDi󰀨erentHardnessValues ………………………………E-30
3.9 Correction Value Setup …………………………………………………………E-31
3.10 Setting the Specimen ……………………………………………………………E-34
3.11 Executing the Test ………………………………………………………………E-35
3.11.1 Executing the Test (First Point) …………………………………………………………E-35
3.11.2 ConrmingtheTestResults(FirstPoint) ………………………………………………E-36
3.11.3 Executing the Test (Second Point) ………………………………………………………E-37
3.11.4 ConrmingtheTestResults(SecondPoint) …………………………………………… E-39
3.11.5 Testing from the Third Point Onwards …………………………………………………E-39
3.12 Retesting …………………………………………………………………………E-40
PART F Brinell Hardness Test
1 Test Flow ………………………………………………………………………………… F-1
1.1 Method to Test One Point ……………………………………………………… F-1
1.2 Method to Set a Group and Test Multiple Points ……………………………… F-3
2 Method to Test One Point …………………………………………………………… F-5
2.1 Test Method Settings …………………………………………………………… F-6
2.2 Display Conditions Settings …………………………………………………… F-7
2.3 Indenter Settings ………………………………………………………………… F-8
2.4 Mounting the Indenter …………………………………………………………… F-9
2.5 Test Force/Time Settings ………………………………………………………… F-9
2.6 Correction Value Settings ……………………………………………………… F-10
2.7 GO/NG Judgment Settings ……………………………………………………… F-10
2.8 Setting the Specimen …………………………………………………………… F-11
2.9 Executing the Test ……………………………………………………………… F-13
2.10 Indent Measurement …………………………………………………………… F-14
2.11 Indent Measurement Value Input ……………………………………………… F-15
2.12 ConrmingtheTestResults …………………………………………………… F-16
2.12.1 ConrmingontheScreen ……………………………………………………………… F-16
2.12.2 ConrmingwithExternalOutput ……………………………………………………… F-16