Mitutoyo HR-530 Series - PART E: Indent Depth Brinell Hardness Test; Test Flow

xix
No. 99MBG518A
PART E Indent Depth Brinell Hardness Test
1 Test Flow ………………………………………………………………………………… E-1
1.1 Method to Test One Point ……………………………………………………… E-1
1.2 Method to Set a Group and Test Multiple Points ……………………………… E-3
2 Method to Test One Point …………………………………………………………… E-5
2.1 Test Method Settings …………………………………………………………… E-6
2.2 Display Conditions Settings …………………………………………………… E-7
2.3 Indenter and Test Force Settings ……………………………………………… E-8
2.4 Mounting the Indenter …………………………………………………………… E-9
2.5 Test Time Settings ……………………………………………………………… E-9
2.6 GO/NG Judgment Settings ……………………………………………………… E-9
2.7 Testing the Test Block …………………………………………………………… E-10
2.7.1 Setting the Test Block …………………………………………………………………… E-10
2.7.2 Executing the Test ……………………………………………………………………… E-12
2.7.3 ConrmingtheTestResults …………………………………………………………… E-13
2.7.4 TestingwithTestBlocksofDi󰀨erentHardnessValues ……………………………… E-13
2.8 Correction Value Setup ………………………………………………………… E-14
2.9 Setting the Specimen …………………………………………………………… E-17
2.10 Executing the Test ……………………………………………………………… E-19
2.11 ConrmingtheTestResults ……………………………………………………E-21
2.11.1 ConrmingontheScreen ………………………………………………………………E-21
2.11.2 ConrmingwithExternalOutput ………………………………………………………E-21
2.11.3 Retesting ……………………………………………………………………………………E-21
3 Method to Set a Group and Test Multiple Points …………………………………E-23
3.1 Test Method Settings ……………………………………………………………E-23
3.2 Display Conditions Settings ……………………………………………………E-24
3.3 Indenter and Test Force Settings ………………………………………………E-25
3.4 Mounting the Indenter ……………………………………………………………E-25
3.5 Test Time Settings ………………………………………………………………E-25
3.6 GO/NG Judgment Settings ………………………………………………………E-25
3.7 Group Settings ……………………………………………………………………E-26