Driving & Safety --- Section 2
The Executive 2005
107
Sound and Window Sensors:
Two sound sensors are used to detect impact noises
(repetitive or single heavy impact) and glass breakage.
Sound sensors are located in the galley and in the bedroom.
Window sensors are located on the bedroom windows
only. These sensors detect window screen movement. If the
screen is opened more than ½ inch, the alarm will sound if
the security system is activated.
Each sensor is equipped with a pair of replaceable batter-
ies. Test sound and window sensors monthly for proper
operation.
To Test Sound Sensor:
• Clap hands loudly next to sensor. LED should
briefly illuminate twice.
To Test Window Sensor:
• Momentarily press on housing next to LED to
briefly illuminate.
Valet Mode:
This feature is useful in servicing, washing or stor-
ing the vehicle. The Valet Mode will not allow the
system to sound an alarm. While in Valet Mode the
Key Fob will lock and unlock the doors. The LED sta-
tus light is a solid glow in the Valet Mode. There are
two ways to access the Valet Mode: With the Key
Fob or the Valet/Program button.
Entering Valet Mode with Key Fob:
1. Open the entry door.
2. Press the LOCK button.
3. Press the UNLOCK button.
4. Press the LOCK button again.
5. Ensure the LED is a steady glow.
Entering Valet Mode with Valet/Program Button:
1. Turn the ignition ON.
2. Turn the ignition OFF.
3. Access Valet/Program button on main dash panel near ignition. Press and hold the
Valet/Program button ten seconds and release.
4. Ensure the LED is a steady glow.
020248
Sound Sensor.
Window Sensor.
020247
To Next Page
Loading...
