Monaco Executive 2005 - Page 108

Section 2 --- Driving & Safety
The Executive 2005
108
Multi-Level Security Arming:
This feature applies to one arming cycle only. The selection of active or bypassed sensor inputs
can be set when arming. Press the LOCK button within five seconds after arming. Each time the LOCK
button is pressed additional zones are bypassed. Reset the system to monitor all zones by turning the
ignition key on.
NOTE:
Press the lock repeatedly to bypass Zones. The system will appear to be non-func-
tional. Reset the Zones using the ignition.
Table of Zones:
• Zone One is Pin Switches. • Zone Four is Bay Doors.
• Zone Two is Warn Away. • Zone Five is Ignition.
• Zone Three is Entry Door.
Quick Reference Guide:
• LOCK - Arms or activates the system.
• UNLOCK - Disarms or deactivates the system.
• LOCK - While driving will arm the system.
• Ignition ON and the Valet button pressed disarms without the Key Fob.
• Ignition ON, then OFF, then pressing the Valet button for ten seconds, enters or exits
the Valet Mode.
• Press and hold the HORN button for one second to enter Panic Mode.
• Press the HORN button to exit the Panic Mode.
• Press the AUX button for Silent Mode Activation.
• LOCK and UNLOCK simultaneously turns Battery Cut-off on and off.
• Hold AUX down for three seconds to unlock bay doors.
Tips:
• Remember the location of the Valet/Program button.
• Know the number of Valet/Program button pulses for disarming.
• A 24 hour support number is located on the back of the Key Fob.
• The headlights will only flash when using the Key Fob.
• The range of the remote Key Fob is approximately 1,200 feet.