Chassis Information --- Section 10
The Executive 2005
459
Master Warning Lamp:
The Master Warning Lamp may illuminate for several reasons with the ignition in the ON or OFF
position.
• When system pressure is below 80 psi.
• When any air bag pressure is below 20 psi.
• When the ignition is on and the system is not in the travel mode.
• When manual or automatic leveling mode is activated.
• When the tag axle (if equipped) is raised. The system will not allow manual or automatic leveling
when the tag axle is raised.
• If the reset button is illuminated.
• If the lamp remains lit, check the above items. In some cases, it may be necessary to set the sys-
tem to back to travel mode by pressing the Travel Mode button or releasing the park brake.
Reset Button:
Should the reset button illuminate, an error may have occurred in the system.
Press the button to reset the system and to turn the panel off. Accidentally press-
ing the reset button in some modes can cause the Master Warning lamp or Reset
Button to illuminate. Press the Emergency Stop button and set the system to
Travel Mode. If the lamp remains illuminated, check the system for a blown fuse
in the control center. If the lamp remains lit after confirming that the fuses are
properly functioning, have the system diagnosed by a qualified technician.
CAUTION:
When the reset light is illuminated, the motorhome will return
to ride height if the ignition is in the on position.
Warning Lamp & Reset Panel
located in Roadside Electrical
bay.
090454
To Next Page
Loading...
