EasyManuals Logo

Monarch NICE1000 User Manual

Monarch NICE1000
205 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
NICE1000
new
User Manual Introduction
- 7 -
Automatic door
open upon door
lock abnormality
If the system detects that the door lock circuit is
abnormal during door open/close, the elevator
automatically opens and closes the door again, and
reports a fault after the set door open/close times is
reached.
Fb-09 (Door open/
close protection
times)
Full-load direct
running
When the car is full-loaded in automatic running state,
the elevator does not respond to hall calls from the
passing oors. These halls calls, however, can still be
registered, and will be executed at next time of running
(in the case of single elevator) or by another elevator
(in the case of parallel control).
-
Overload protection
When the car load exceeds the rated elevator load, the
elevator alarms and stops running.
-
Fault data
recording
The system automatically records detailed information
of faults, which helps improve the efciency of
maintenance and repair.
Set in group FC
Inspection-related Functions
Shaft auto-tuning
Shaft auto-tuning is required before rst-time automatic
running. During shaft auto-tuning, the elevator runs
from the bottom oor to the top oor at the inspection
speed and automatically records all position signals in
the shaft.
Refer to section
5.1.2
User-dened
parameter display
You can view the parameters that are modied and
different from the default setting.
Set in FP-02
Inspection running
After entering the inspection state, the system cancels
automatic running and related operations. You can
press the up or down call button to make the elevator
jog at the inspection speed.
-
Motor auto-tuning
With simple parameter setting, the system can obtain
the motor parameters no matter whether the motor is
with-load or without load.
Refer to section
5.1.1
Floor position
intelligent
correction
Every time the elevator runs to the terminal oor, the
system automatically checks and corrects the car
position information based on slow-down switch 1, and
eliminates over travel top terminal or bottom terminal
with use of the slow-down switches.
-
Dual-speed for
inspection
Considering inaccurate running control at high
inspection speed but long running time at low
inspection speed, the system provides the dual-
speed curve for inspection, which greatly improves the
efciency at inspection.
-
Test running
The test running includes the fatigue test of a new
elevator, car call oor test, hall call test, and tests
such as hall call response forbidden, door open/close
forbidden, terminal oor limit switch shielded, and
overload signal shielded.
Set in F6-10

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Monarch NICE1000 and is the answer not in the manual?

Monarch NICE1000 Specifications

General IconGeneral
BrandMonarch
ModelNICE1000
CategoryController
LanguageEnglish

Related product manuals