Final Adjustments
3-2 Manual # 42-02-2P24
Basic Service Parameters
Parameters accessed through the F1 (Program Mode) function on the HC-MPU board define the
building, floors and openings to be serviced, and other basic requirements for the elevator.
Before the controller is shipped, these basic service definitions are set according to the survey
forms for the job. However, you must verify Basic Features Menu settings are correct for the job
before proceeding.
Please refer to “Basic Features Menu” on page 4-13 for basic service setup.
Learning Floor Levels & Counterweight Position
The following table is provided so that you can enter floor heights and offsets for your records.
The F6 menu provides a process to learn the floor levels and counterweight position for the
building. The process is different depending on the type of landing/positioning system for the
job.
Table 3.1 Floor Height and Offset Notation
Floor Height Offset Floor Height Offset
117
218
319
420
521
622
723
824
925
10 26
11 27
12 28
13 29
14 30
15 31
16 32
To Next Page
Loading...