Motion Control Engineering Motion 4000 User Manual

Auto Tuning and Encoder Data Loading
2-27
2
Motion 4000
Auto-tuning AC Motors to the Magnetek Drive
Auto-tuning provides better drive to motor matching and performance and must be performed
at some point during installation or adjustment. Because the car must be run through the extent
of the hoistway, this procedure should be accomplished after hoistway installations are suffi-
ciently complete. Please refer to Adaptive Tuning in the Magnetek manual and follow those
instructions.
Tuning Motor No-Load Current (HPV 600/900/900II Only) Please see Tun-
ing No-Load Motor Current in the appendix of the Magnetek HPV AC Drive Technical Manual
for specific steps.
Tuning Motor Flux Saturation Curve (HPV 600/900/900II Only) Please
see Tuning Motor Flux Saturation Curve in the appendix of the Magnetek HPV AC Drive Tech-
nical Manual for specific steps.
Tuning Motor Rated RPM (HPV 600/900/900II Only) Please see Tuning
Rated Motor RPM in the appendix of the Magnetek HPV AC Drive Technical Manual for spe-
cific steps.
Determining System Inertia Please see Using the Software to Estimate the System
Inertia in the appendix of the Magnetek HPV AC Drive Technical Manual for specific steps.
The Drive Manual
The information included above is very basic. If you are not familiar with the Magnetek drive,
you must take a few minutes to look through the drive manual to learn how to proceed, what to
expect, and what adjustments are available through the drive.

Motion Control Engineering Motion 4000 Specifications

General

Brand	Motion Control Engineering
Model	Motion 4000
Category	Controller
Language	English