Motion Control Engineering Motion 4000 User Manual

Operating Mode Descriptions
1-11
1
Motion 4000
Attendant Operation
Attendant operation allows an operator riding in the car to run the car, choosing run direction,
and which hall calls to answer. In this mode:
• Doors open automatically when the car is stopped in a door zone.
• The attendant closes the door by pressing and holding the door close button, a car call but-
ton, or either car direction (UP/DOWN) button (UPI/DNI input: Please refer to “Spare
Inputs Menu” on page 4-26.)
• The attendant chooses the direction using run up (UNI) or down (DNI) buttons.
• The car will stop at the next car or hall call in the direction of travel. Holding the bypass
button (NSI input) in will cause hall calls to be bypassed until the button is released. An
annunciator panel is required if in-car visibility of hall calls is required.
• The elevator will level into the destination floor automatically, then open its doors.
• During Attendant operation, load weigher inputs are ignored.
Mode Entry
• Call the car to a floor.
• Enter the car and activate the Attendant mode key switch (enables the ATS, Attendant Ser-
vice, controller input).
Independent Service
In this mode:
• The car is removed from hall call dispatching
• Doors open automatically when the car is stopped in a door zone
• The operator presses and holds the door close button to close doors
• The operator chooses direction and initiates the run by placing car calls (first placed deter-
mines direction of run).
• The elevator will level into destination floors automatically and open its doors.
• Hall arrival lanterns or jamb mounted arrival lanterns are inoperative.
Mode Entry
• Call the car to a floor.
• Enter the car and activate the Independent mode key switch (IND input HC-CTL board).

Motion Control Engineering Motion 4000 Specifications

General

Brand	Motion Control Engineering
Model	Motion 4000
Category	Controller
Language	English