Motion Control Engineering Motion 4000 User Manual

F3: System Mode
4-53
4
Motion 4000
F3: System Mode
System mode allows the user to change certain system-wide options that do not require the car
to be on Inspection. To enter System mode:
•Move the F3 switch to the up position (all others down).
• Press N to select the desired System Mode item.
• Building Security Menu (see page 4-53)
• Passcode Request Menu (see page 4-56)
• Load Weigher Thresholds (see page 4-57)
• Analog Load Weigher Learn Function (see page 4-57)
• Controller System Menu - real time speed and position indication (see page 4-49)
Building Security Menu
Elevator Security is used to limit access to specified floors to passengers with a valid security
code. The Security code for each floor is a sequence of button presses on the car operating panel
and may consist of from one to eight “characters”. Any floor with a programmed security code is
a secured floor when Security is ON. Security is turned ON or OFF by the controller Building
Security Input (BSI) in combination with the Master Software Key parameter in the Extra Fea-
tures Menu (Program mode). There are three possible settings for the Master Software Key:
ACTIVATED, ENABLED, and DEACTIVATED:
• If set to ACTIVATED, Security is ON.
• If set to ENABLED, Security is ON when the BSI input is turned ON.
• If set to DEACTIVATED, Security is OFF regardless of the status of BSI.
To find the BSI input, refer to the job prints. When Security is ON, car calls are registered only if
the call is not to a secured floor or the call is to a secured floor and the security code is correctly
entered within 10 seconds.

Motion Control Engineering Motion 4000 Specifications

General

Brand	Motion Control Engineering
Model	Motion 4000
Category	Controller
Language	English