Setting Motion/Position Parameters
3-9
3
Motion 4000
Setting Motion/Position Parameters
Floor heights, terminal switches, drive, and machine characteristics that influence speed and
position computation must be set up through the F7 menu before attempting to bring the car up
to contract speed. Please refer to “F7: Parameters Adjust” on page 4-118 for setting instruction.
Often Used Procedures
Following are some procedures and techniques that may be frequently used when adjusting the
car:
How to check Car Speed:
1. Place Function Switch F3 on the HC-MPU board in the ON (up) position.
2. Press the N push button until CONTROLLER SYSTEM MENU is displayed.
3. Press the S push button to select the menu.
4. Press the N push button until POSTN and SPEED are displayed.
5. Run the car. Speed is displayed in feet per minute.
How to place the car on Inspection Mode Fault Bypass:
1. On the HC-MPU board, place Function Switch F3 in the ON (up) position.
2. On the HC-CTL board, use a jumper to short the pins of JP1 Fault Bypass.
3. Press the N push button until CONTROLLER SYSTEM MENU is displayed.
4. Press the S push button to select the menu.
5. Press the N push button until INSPECTION MODE FAULT BYPASS is scrolled on the
display. (All faults, other than MPI-C Inspection Overspeed are bypassed.)
6. Press the S push button to change the setting to BYPASS ON. (Remains bypassed even
through power cycle, until reset.)
How to place the car on Automatic Mode Fault Bypass:
1. On the HC-MPU board, place Function Switch F3 in the ON (up) position.
2. On the HC-CTL board, use a jumper to short the pins of JP1 Fault Bypass.
3. Press the N push button until CONTROLLER SYSTEM MENU is displayed.
4. Press the S push button to select the menu.
5. Press the N push button until AUTOMATIC MODE FAULT BYPASS is scrolled on the
display. (All faults other than MPI-C Contract Overspeed are bypassed.)
6. Press the S push button to change the setting to BYPASS ON. (Times out automatically
after two hours.)
To Next Page
Loading...
Need help?
General
