User Interface
4-56 Manual # 42-02-2P24
Passcode Request Menu
The Passcode Request Operation can be used to require password entry to run the car on any
mode of operation other than Inspection.
If a passcode has not been programmed, the Passcode Request Menu will not appear.
If a passcode has been programmed, the LCD screen will
flash the “PASSCODE REQUEST” message when Passcode
Request Operation is activated.
In order to clear or set the Passcode Request Operation, the
controller must first be placed in System Mode (F3 up, all
others down).
• Press N when the display reads “BUILDING SECURITY
MENU.” The Passcode Request Menu will appear:
Entering the Passcode
Press S. If Passcode Request Operation is activated, the fol-
lowing screen appears:
The first character of the passcode will blink. Use + - to
scroll through numbers 0-9 and letters A-Z for each charac-
ter. Press N to advance to the next character position.
Press S to verify the entry is correct. If it is not, the following
screen will appear:
Press S to try again. Press N to exit.
If the correct passcode was entered, the following screen
appears:
Press N to exit. The car may now be run on Normal opera-
tion mode.
To Next Page
Loading...
Need help?
General
