F5 Menus
4-65
4
Motion 4000
Clear Event Log
This allows you to clear the events from the event log.
1. Press S to select the clear function.
A prompt will appear allowing you to back out without clearing events (Yes/No).
2. To clear the log press the S button when prompted.
A message will appear notifying you that all events have been cleared.
Default TC-MPI Parameters
This selection allows you to default the TC-MPI board to factory defaults.
1. Press S to select.
2. Press S to confirm or N to back out.
3. Message MPI Parameters are defaulted will be displayed.
Use the F7 function to upload the defaulted parameters from the TC-MPI (F7: Parameters
Adjust on page 4-118).
To Next Page
Loading...