Motion Control Engineering Motion 4000

Installation
2-18 Manual # 42-02-2P24
Figure 2.4 Torqmax Display
Keypad Operation
Please refer to “KEB Keypad Overview” on page 2-19.
Clear Error
If an error is displayed (E. UP, etc.), the drive will shut down. To clear the error:
• Press ENTER
The E.ENCC error is an exception and must be cleared using parameter LF.26.
Parameter group
(LF, LP, US, etc.)
Parameter number
ON when drive
is transmitting
ON = Normal
BLINKING = Error
Blinking “point” means
that segment (group or
number) is ready to
accept an entry