Motion Control Engineering Motion 4000

General Settings Log
A-23
A
Motion 4000
SPARE INPUTS
SPIN1 on HC-CTL used for:
SPIN2 on HC-CTL used for:
SPIN3 on HC-CTL used for:
SPIN4 on HC-CTL used for:
SPIN5 on HC-CTL used for:
SPIN6 on HC-CTL used for:
SPIN7 on HC-CTL used for:
SPIN8 on HC-CTL used for:
SPIN9 on HC-CTL used for:
SPIN10 on HC-CTL used for:
IO 1, UIO 32 used for:
IO 2, UIO 32 used for:
IO 3, UIO 32 used for:
IO 4, UIO 32 used for:
IO 5, UIO 32 used for:
IO 6, UIO 32 used for:
IO 7, UIO 32 used for:
IO 8, UIO 32 used for:
IO 1, UIO 33 used for:
IO 2, UIO 33 used for:
IO 3, UIO 33 used for:
IO 4, UIO 33 used for:
IO 5, UIO 33 used for:
IO 6, UIO 33 used for:
IO 7, UIO 33 used for:
IO 8, UIO 33 used for:
IO 1, UIO 34 used for:
IO 2, UIO 34 used for:
IO 3, UIO 34 used for:
IO 4, UIO 34 used for:
IO 5, UIO 34 used for:
IO 6, UIO 34 used for:
IO 7, UIO 34 used for:
IO 8, UIO 34 used for:
IO 1, UIO 35 used for:
IO 2, UIO 35 used for:
IO 3, UIO 35 used for:
IO 4, UIO 35 used for:
IO 5, UIO 35 used for:
IO 6, UIO 35 used for:
IO 7, UIO 35 used for:
IO 8, UIO 35 used for:
IO 1, UIO 36 used for:
IO 2, UIO 36 used for:
IO 3, UIO 36 used for:
IO 4, UIO 36 used for:
IO 5, UIO 36 used for:
IO 6, UIO 36 used for:
IO 7, UIO 36 used for:
IO 8, UIO 36 used for:
CPI F I10
CPI F I11
CPI F I12
Program Mode (F1) Parameter Settings Record
OPTIONS CURRENT VALUES
NEW VALUES