To change the GEO code manually, follow the instructions outlined below.
Changing the GEO code modifies the weight values the Mailing
System calculates. Make sure you enter the correct GEO Code to
ensure your weights are accurate.
How to change the GEO Code
To change the GEO Code:
1.
Log in as the Supervisor (see How to log in as Supervisor on page 184 ), then:
Press and type 6.2.2 or select the path:
System Settings Accessories and Module Settings GEO code
2. See the map and table on the next pages to get the 5 digits GEO code from your
location altitude and latitude, and enter the 5 digits using the keypad.
3. Press [OK] to validate the GEO code.
202
| Page 202 | | janv.-12-2012 11:42 |
8
Configuring your Mailing System
To Next Page
Loading...
Need help?
General
