2.
Press to start.
The Mailing System prints the Meter Impression and the mail piece is sent to the Catch
Tray.
Running in Seal Only Mode
This section describes the system settings to be selected and the mail preparation steps
to be completed in order to run your system in Seal Only Mode.
Seal Only Mode is used for:
•
Sealing envelopes that do not require a Meter Impression or already have Meter
Impression.
•
Conveying mail for Batch Counting or system testing purposes.
See also
•
Introducing Tasks on page 38.
Set-Up Requirements
The instructions below outline the steps that you need to complete to set up your system
to run in Seal Only Mode.
•
As mail requirements differ from day to day, some of the Impression Options may
not be necessary, or their order may vary.
•
Begin by selecting a Meter Impression to gain access to the Impression Options that
you may need to process your system in Seal Only Mode.
Make sure you have completed the preparation steps mentioned
in Sorting Mail by Type and Task on page 40.
How to process Mail without Printing an Impression
(Settings)
Main setting:
3
Processing Mail
67
| Page 67 | janv.-12-2012 11:42 |
To Next Page
Loading...
Need help?
General
