2.
Press to start.
The system weighs the first mail piece and asks you to confirm the postage amount
before applying it to the mail pieces remaining in the stack.
3. Press [OK] to confirm.
The system will now feed (seal), and print the entire stack of mail without weighing
the remainder of the batch.
Processing Mail Using the External Weighing Platform
The external Weighing Platform can be used for large, heavy or bulky mail that cannot be
run through the Mailing System with a Dynamic Weighing Module. On the other hand, if
you do not have the optional Dynamic Weighing Module, you will need to use the platform
to weigh and rate all your mail.You may weigh and rate mail to print directly on the mail
piece, or print a Label that will be applied to the mail piece.
Once you have performed the recommended job set-up (Recommended Mail Processing
Steps on page 38 and Recommended System Set-up for Processing Mail on page 51),
you are ready to process mail.
Follow the steps below to use the Weighing Platform in the Standard Mode.
See also
•
Processing Mail Using Differential Weighing on page 55
Processing Mail in Standard Weighing Mode
1.
Place a mail piece on the external Weighing Platform (WP).
The weight of the piece is updated in the Weight area of the screen and the postage
amount displayed.
You can print directly on the mail piece or on a Label if the mail piece is too thick or
too large to process through the machine (see Mail Specifications on page 277 ).
To print an impression on one or more identical envelopes
1.
Press .The system motors will start running.
At any time, to stop the motors and printing, press .The System
will process any mail piece(s) already in the print path and then
stop.
3
Processing Mail
53
| Page 53 | janv.-12-2012 11:42 |
To Next Page
Loading...
Need help?
General
