Running Mail
Once you have completed setting up your Impression, follow the instructions below to
process your mail.
How to correct the Date (Running Mail)
To print a Meter Impression with a new Date or Advanced Date:
1.
Press .The system motors start running.
2.
Insert the mail piece(s) into the mail path against the rearguide wall, side to be printed
facing upwards (see How to use the Feeder on page 91 ).
The Mailing System applies the postage and the mail piece (or Label) is sent to the
Catch Tray.
If your mail piece is larger than mail path’s maximum thickness (see Mail Specifications
on page 277 ), press before you press to print a Label.The Label is printed.
If you want to print multiple Labels:
1.
Press and enter the number of Labels.
Make sure the Label Dispenser is full (see Filling the Automatic Label Dispenser on
page 96 ).
2.
Press to print your Labels.
Postage Value Correction Mode
In this Section
This section describes the system settings to be selected and the mail preparation steps
to be completed in order to print a Postage Value Correction Meter Impression.
This type of Meter Impression corrects the postage amount that has already been printed.
Only corrections that increase the postage amount are possible.
3
Processing Mail
59
| Page 59 | janv.-12-2012 11:42 |
To Next Page
Loading...
Need help?
General
