Newtec Proprietary
Confidentiality: Unrestricted
V1.0
92/314
General Device Settings and Actions MDM6000 Satellite Modem
12 General Device Settings and Actions
12.1 Access Control
Before implementing the device into a network it is recommended to consider which management
channels need to be enabled.
It is recommended to disable unused services to prevent unauthorized access to the
device. By default SNMP, CLI and FTP are enabled.
Login as expert user and navigate to the following locations to enable or disable these settings.
MDM6000 >> Device Setup>> Access Control >> SNMP
MDM6000 >> Device Setup>> Access Control >> CLI
MDM6000 >> Device Setup>> Access Control >> FTP
MDM6000 >> Device Setup>> Access Control >> Frontpanel
Once the frontpanel is put into read-only mode it can only be changed back to
read-write mode via one of the other available interfaces.
For example via the craft interface by using the CLI.
(This is the backdoor when the management IP address has changed and the device
is unreachable through IP connectivity).
To Next Page
Loading...
