Newtec MDM6000 - Command Line Interface (CLI); How to Access the CLI

Newtec Proprietary
Confidentiality: Unrestricted
V1.0
73/314
How to Manage the Device MDM6000 Satellite Modem
11.7 Command Line Interface (CLI)
This section describes how the device can be managed using the CLI.
The commands and how they can be applied are described in the following section.
11.7.1 How to Access the CLI
Access the CLI via an Ethernet management interface or via the craft interface by using a RS232
serial cable.
Management Interface
To access the CLI via the management interface do the following:
» Configure the IP address of the management interface using the front panel.
Make sure that the IP address of the MDM6000 Satellite Modem is in the same range
as the IP address of the managing device or that a default gateway is configured.
» Make an Ethernet connection between the managing device and the MDM6000.