Newtec Proprietary
Confidentiality: Unrestricted
V1.0
6/314
Safety Regulations MDM6000 Satellite Modem
3 Safety Regulations
Please read this chapter before you install and use this equipment.
To ensure your safety, the equipment has been designed to comply with the following safety
standards:
Safety of Information Technology Equipment.
• IEC 60950-1:2006/A11:2009/A1:2010/A12:2011
• EN 60950-1:2006/A11:2009/A1:2010/A12:2011
• UL 60950-1, Second Edition
• CSA C22.2 N°. 60950-1-07.Second Edition
Before you start to install and operate the device, please make sure you observe the following
points:
• The equipment described in this manual is designed to be used by properly trained personnel
only. Only qualified personnel who are aware of hazards involved may adjust, maintain and repair
the exposed equipment.
No operator serviceable parts inside. Refer servicing to qualified personnel.
To prevent electrical shock, do not remove covers.
• To use the equipment correctly and safely, it is essential that both operating and servicing
personnel follow generally accepted safety procedures in addition to the safety precautions
specified in this manual. Warning and caution statements and/or symbols are marked on the
equipment when necessary. Whenever it is likely that safety protection is impaired, immediately
switch off the equipment and secure it against unintended operation. Inform the appropriate
servicing authority about the problem. For example, safety is likely to be impaired if the
equipment fails to perform the intended measurements or shows visible damage.
• The only way to shut down the device is to disconnect the power cable from the power
connector. Therefore make sure that the power cable is accessible and not obstructed when the
device is operational. For more information please refer to section: PowerConnectoronpage23.
To Next Page
Loading...
